EUROM Force 1012 wet/dry Livret D'instructions page 12

Cleaning the filter
Clean the filter regularly. Open both clips and remove the lid of the vacuum cleaner. Slide
the filter off the frame and carefully wash with lukewarm water. Do not use any
aggressive or abrasive cleaning agents!
Let the filter dry thoroughly before replacing. Never use the device without a filter!
Maintenance:
 Keep the body of the device, the filter and accessories clean by wiping them with a dry
or damp cloth. Do not use aggressive cleaning materials!
 Regularly check to ensure no excess air is being sucked in.
 Check the cable and plug regularly for damage. Do not use the device if it has a
damaged cable and/or plug but take it to an authorised engineer to be replaced!
 Regularly check to ensure no objects are stuck in the suction mouth, hose or pipe.
Remove them if necessary.
 Use the device carefully; ensure it does not fall, bump into other objects or become
otherwise damaged.
 Store the device in a dry environment.
 Never use the device for too long in one go; give it regular opportunities to cool down.
This will extend its life expectancy.
 If the device falters, vibrates, makes peculiar noises or emits a burning smell, stop
using it immediately and ask your supplier or service provider to check/repair it.
CE - STATEMENT
Eurom-Genemuiden-NL hereby declares that the EUROM FORCE vacuum cleaner type
1012 wet/dry complies with the LVD guideline 2014/35/EU, the EMC guideline
2014/30/EU and Rohs guideline 2011/65/EU and meets the following standards:
EN 62233:2008
EN 60335-2-2:2010+A11 :12+A1 :13
EN 60335-1:2012+AC :14+A11 :14
Genemuiden, 22-08-2016
W.J. Bakker, alg. dir.
12
EN 55014-1 :2006/+A1 :2009/+A2 :2011
EN 55014-2 :1997/+A1 :2001/+A2 :2008
EN 61000-3-2 :2014
EN 61000-3-3 :2013