EUROM Force 1012 wet/dry Livret D'instructions page 11

11
 Be carefull!
 Never vacuum dust without the dust bag!
 Never vacuum liquid with the dust bag!
 Never vacuum liquid without the filter around the floater!
Blowing
By connecting the suction hose to the blower opening (instead of the hose connector)
you can blow instead of vacuuming. Operation is otherwise the same.
CLEANING UP
Switch the device off and remove the plug from the socket. Place the accessories at the
appropriate locations on the device, see image.
OVERHEATING SAFEGUARD
In case of internal overheating, the overheating safeguard will switch the device off. This
may occur if the device cannot give off enough heat or if it cannot draw in enough fresh
air. This is generally caused by (partially) covering the device, obstructing the air intake
and/or outlet grills or installing the device too close to a wall or something similar. When
the device has cooled down sufficiently, it will in principle start again automatically,
however if you do not remove the cause of the cut-off then this will probably be
repeated. Regular overheating can give rise to irreparable damage.
When the overheating safeguard switches the device off, set the switch to 'off'(O),
unplug and allow the device to cool down. Remove and/or amend the cause of
overheating and reuse the device as normal. If you cannot find a cause and overheating
recurs, stop using the device, and take it in for inspection/repair.
CLEANING AND MAINTENANCE
Before cleaning or maintenance: always switch off the equipment and unplug it.
Emptying dust bag
Open both the locking blocks (4) en take the up housing from the vacuum cleaner.
Remove the dust bag from the body of the device and open by sliding the plastic clamp
off. Empty the dust bag, shake it until it is clean and connect once again. Replace in the
device correctly. At the end, place back the up housing and close the locking blocks.
Emptying barrel
Open both the locking blocks (4) en take the up housing from the vacuum cleaner.
Remove the liquid out of the barrel and clean the barrel if necessary. At the end, place
back the up housing and close the locking blocks.