EUROM Force 1012 wet/dry Livret D'instructions page 10

The device is fitted with a reusable, textile dust bag. This dust bag has a round opening
with a rubber strip. Before you start dry-vacuuming, you must place the bag in the body
of the device and slide the opening over the hose inlet until it is sealed. Remove the bag
when wet-vacuuming.
OPERATION
Dry vacuum cleaning:
 Check to ensure that the dust bag is installed
correctly in the body of the device. Close the
body of the device properly with the clamps.
 Insert the hose as far as it will go into the hose
connector: you may turn it until the catch falls
into the recess. Then turn it a quarter clockwise.
 After this, connect the accessories you wish with
a twisting force.
 Insert the plug into the socket.
 Press the ON-switch (I) to turn on (and press later
on the off-switch (O) to turn off).
 You can adjust the airflow by pushing the sliding block 1B up and down.
Wet vacuum cleaning:
 For the vacuuming of liquid the motor (which is situated in the cap) is provided with a
floater that is hanging under the motor, in the barrel. For the vacuuming of liquid the
motor is provided with a filter that the floater surrounds and in that way prevents that
objects enter the mechanic system. Never vacuum liquid without the filter around the
floater!
10
Standard accessories:
1. Hose
1A. Hose connection
1B. Sliding block airflow
2. Tube (3 x 36 cm.)
3. Crevice nozzle / Dust brush
4. Combi floorbrush