RugGear RG150 Mode D'emploi page 7

it carefully to open the compartment.
3.2. Insert the microSD card and the SIM cards into
the corresponding slots. The device supports up
to 32Gb with a memory card.
4. Installing and uninstalling the battery
4.1. Turn off the phone.
4.2. Unfasten the battery screws on the battery cover
and lift it carefully to open the compartment.
4.3. Insert the phone battery, aligning the contacts
on the unit with the connectors inside the
compartment.
4.4. Replace the battery cover and press it down
carefully until it locks into place.
4.5. Fasten the screws on the battery cover.
Note Note
Make sure the battery cover, cover screws, earphone Make sure the battery cover, cover screws, earphone Make sure the battery cover, cover screws, earphone
and USB plugs are fi rmly fastened to prevent water and USB plugs are fi rmly fastened to prevent water and USB plugs are fi rmly fastened to prevent water
and dust from entering the phone. and dust from entering the phone.
Do not remove the USB cable while copying fi les in
USB mode. Exit the USB mode fi rst and then remove
the USB cable to prevent losing data.
5. Charging your phone
5.1. Open the rubber plug on the bottom of the phone.
5.2. Connect the USB cable to the USB port on your
phone.
5.3. You must fully charge your phone for 12 hours
prior to using it for the fi rst time.
6. Caution
It is recommended to use the type of battery
specifi ed by the manufacturer. Use of a diff erent
type may cause the battery to explode.
Dispose of used batteries in a designated place.
The normal operating temperature of your phone
EN
7