Bimar HC501 Notice D'instructions page 20

"

Timer
stop automatically. To set the time, press
time it is pressed it selects (1 hour - 2 hours - 4 hours
To deactivate the timer, press the button until the display time
disappears. If the timer is not activated, the device works until it is
turned off.

Remote control, to select all the functions described above. The
remote must be pointed at the display, and before insert the battery
(open the rear door and insert 2 batteries "AAA" with correct polarity,
close the door). With each change of function you will hear a beep.
Furthermore, the appliance is equipped with a switch that stops the
rollover operation in case of a fall. Reposition it vertically, you activate
standby.
To use the heater, proceed as follows:
 Before inserting the plug into the power outlet to verify that the
switch is in pos. "0".
 Insert the plug into the socket.
 Turn the switch in position "I" and you will hear a beep, the display
lights up and shows the temperature (TEM) and the recently set
temperature (SET). The device is in standby mode, and if you do
not select any buttons, after about one minute, the display turns
off.
 Press "
" to activate the resistance 800W and 800W the display
(warm low power); Press "
comfortable), a second time if you want to 2000W (instant hot).
 To activate the timer, press the "
 If desired, press the "
to turn it off.
 To operate the heater to adjust the temperature "SET" more than
room "TEMP". To adjust the temperature, press the "+" or "-" until
the desired value; the resistance is activated only when the
ambient temperature is lower than set.

To turn off the unit press
from the plug point.
"
(G), sets the time of operation, after which the unit will
", to operate the fan and a second time
" "
"
" once to activate 1200W (heat
" button.
, switch in pos.0, and remove the plug
20
"
repeatedly: each
...
15 hours).