Bimar HC501 Notice D'instructions page 18

- Place the feet on the heater by inserting the slots in their hooks
and slide them until they lock into place.
- Use the screws provided to secure them in place.
The device is equipped with an anti-tip system switch which "clicks"
when the heater is tilted: it is therefore normal to hear a noise inside
every time you move the heater.
 Before connecting the heater check that the voltage shown on the
specifications plate corresponds to that of the electrical supply, and
that the plug is effectively grounded. In the event of incompatibility
between the power supply and the plug, have the plug replaced with
a suitable model by a qualified professional, who should ensure that
the size of the cable is suitable for the power used by the unit. The use
of adaptors or extensions is generally not advisable; if it is necessary
to use them, they must comply with safety regulations and the total
current (amps) must not be rated lower than the maximum current of
the the appliance.
 Place the convection heater far from any other source of heat, from
flammable material (curtains, tapestries, etc.), from flammable gases
or flammable material (spray cans) and from materials that can be
deformed by heat. Make sure there is 100cm of free space in front of
the heater and 50cm free space on both sides and at the back.
 Do not use this appliance near a bath, a shower or a swimming pool;
(to avoid water droplets falling on the appliance and the appliance
falling into the water); if this happens, do not place your hand in the
water but first turn off the power supply by turning off the switch on
the electrical panel, and only then remove the plug from the plug
point. Carefully dry both the plug and the socket before restoring
power. Plug into the power point and then continue using the device.
If in doubt consult a qualified professional.
 The surface must be stable, not sloping (as the unit may fall over), heat
resistant.
 Ensure that the power cable is correctly positioned and does not
come into contact with hot parts or sharp edges, nor become wound
around the appliance itself, is not twisted and does not snag, in order
18