Bimar HC501 Notice D'instructions page 17

 Do not leave the appliance exposed to atmospheric
conditions (sun, rain, etc..).
 Should the appliance fall or not work correctly,
disconnect the electric cable immediately. Check that it is
not damaged, and thereafter turn it back on: if in any
doubt, consult a qualified professional.
 Do not pull on the power cable or the appliance itself to
unplug the appliance from the mains.
 Do not pull on the power cable to move the appliance.
 Do no use the appliance if it does not work properly or if it
appears damaged; when in doubt, contact a qualified
technician.
 Avoid allowing the appliance to overheat; to this end,
check that the inlet and outlet are free from obstructions:
do not leave anything hanging over or under the unit.
Should overheating occur, the in-built safety device will
stop the convection heater from running. To restore
operation, remove the plug from the mains and wait for it
to cool (about 20-30 minutes) and insert the plug into the
plug point once again.
INSTALLATION
 After unpacking, check the integrity of the appliance; if in doubt, do
not use it and contact a qualified technician. The packaging materials
(plastic bags, polystyrene, metal staples, etc.) must not be left within
reach of children, as they constitute possible safety risks and must be
disposed of according to applicable regulations.
Warning: the heater must run only if its feet are correctly assembled.
To use the machine, equally assemble the two feet supplied as follows
(see figures below):
- check that the power cable is disconnected from the plug point
- Place the device horizontally on a flat, smooth surface.
17