Aventics MSV8 Instructions De Montage page 5

AVENTICS | MSV8 | R422103410–BAL–001–AA | English
3 Delivery Contents
The delivery contents include:
W
1x MSV8 2/2 or 3/2 micro solenoid valve
W
Assembly instructions
Accessories must be ordered separately.
Valve accessories including retaining clips, mounting screws,
single manifold block, and valve plug connectors can be found
at: www.aventics.com
4 About This Product
Product description
The MSV8 2/2 and 3/2 micro solenoid valves are used to
directly control fluids including neutral gas and neutral liquids
or as a pilot valve for pneumatic actuators. The MSV8 series is
electrically operated.
Overview of MSV8 micro solenoid valve
1 2/2 or 3/2 micro solenoid
valve
2 Electrical connection
3 Identification plate
4 Valve groove
5 Ports A, B, C
Product identification
Comply with the product information on the product
1 3
(or ) and the packaging.
5 Assembly
The product is a component. Observe the documentation for
the overall system during disassembly and assembly!
Danger of injury if assembled under pressure or voltage!
Assembling when under pressure or voltage can lead to
injuries and damage to the product or system components.
Danger of injury from electric shocks and sudden pressure
drops.
O Make sure that the relevant system part is not under
voltage or pressure before you assemble/disassemble
the product.
O Ensure that the system cannot be switched on.
1
6 Plug-in mounting hole
7 Single manifold block
8 Retaining clip
9 Mounting screw M2x3
CAUTION
Installation requirements
The MSV8 micro solenoid valve can be assembled as follows:
W
As a plug-in valve cartridge using a suitable plug-in
mounting hole shown in Fig.
W
In a single manifold block as can be seen in Fig.
For the dimensions and pneumatic functions of the MSV8
micro solenoid valve, please see Fig.
Assembling the valve
Proceed as follows during installation:
1. Make sure that the system is not under voltage or
pressure.
2. Carefully guide the MSV8 valve into a plug-in mounting
hole 5 or into a single manifold block (
Do not use any oil or lubricant for assembly of the
valve because this can lead to heavier leakage than
stated in the online catalog (www.aventics.com).
3. Position the retaining clip (
4) and fasten with a M2x3 screw (
Tightening torques for M2x3 screws: 0.75 ± 0.25 Nm
4. Connect the electrical connection using valve plug
connector
6 Disposal
O Comply with national regulations regarding disposal.
2
7 Maintenance and
Troubleshooting
The product is maintenance free.
If you cannot remedy a malfunction, please contact one of the
addresses found under www.aventics.com or exchange the
valve.
8 Technical Data
Technical data can be found in the pages for individual
components in our online catalog (www.aventics.com).
9 Spare Parts and Accessories
Information on spare parts and accessories can be found in
the online catalog (www.aventics.com).
5
3
1
1
8) in the valve groove (
1
4 .
4
1
7.
.
1 7).
1
9).