Dometic RM122 Instructions De Montage Et De Service page 17

RM122, RM123
➤ Seal the hole with non-flammable sealant (fig. a 1, page 5).
➤ Fix the cover plate with four screws on the outer wall of the vehicle
(fig. 9 3, page 5).
7.6 Installing cover plate above the refrigerator door
➤ Screw a block of wood on each side with the dimensions 25 x 66 mm on
both sides of the recess.
➤ Mount the blocks 16 mm offset inwards, so that the cover plate flush with
the front of the kitchen furniture (fig. 8 2, page 5).
➤ Screw the cover plate on the blocks.
7.7 Reversing the door hinge
A
NOTICE! Risk of damage
Lay the refrigerator on the side only, never on the backside.
Otherwise the aggregate may be damaged.
The refrigerator is delivered with the door hinge on the right. This is how to
reverse the door hinge:
➤ Turn the refrigerator on the side.
➤ Pull the knob of the temperature switch.
➤ Loosen the two screws and remove the lower cover plate.
➤ Remove the top hinge leaf and the closure plate.
➤ Hold the upper hinge leaf and the closure plate to the desired side and at-
tach it to the lower hinge leaf from the opposite side.
➤ Install the vent grille with the two screws.
➤ Press the knob of the temperature switch to the spindle so that it is fixed
in the recess.
➤ Wait a few hours before starting the refrigerator.
EN
Installing the refrigerator
17