Loader Pump; Priming; Overview; Prime - Lincoln SKF 500CLR Instructions D'utilisation Et D'entretien

WARNING

Do not use high-pressure grease fittings
as a loader fitting.
High pressure fittings will create
excessive pressure in grease cartridge.
Failure to comply may result in death
or serious personal injury.

Loader pump

1 Wipe loader fitting (15) with clean cloth.
1 Seat loader coupler (9) (80133 or 27412)
into fitting (15) on pump.Engage follower
rod (12) with follower by rotating
follower T-handle (1).
2 Insert valve (7) into coupler (9).
3 Extend lever (2) away from
container tube.
4 Operate filler pump to fill cylinder (6).
NOTE
When follower rod groove (13) is
exposed, cylinder (6) is full.
Follower rod (12) will be extended
approximately 8 in (203 mm).
5 Disengage follower rod (12) from
follower by rotating follower handle.
6 Push follower rod (12) into cylinder (6).
7 Refer to Priming.

Priming

Overview

Priming a grease gun depends on:
– viscosity of grease
– temperature of grease
– condition of gun.
NOTE
Do not try to prime with switch (4) in
pressure (P) position. Prime only in
volume (V) position.

Prime

1 Place selector valve (4) in volume (V)
position.
2 Operate lever (2) several times until
grease is being pumped from coupler (9).
NOTE
If grease is not being pumped from
coupler (7) after operating lever (2)
several times, remove trapped air.
3 Turn valve (7) counter-clockwise to open.
4 Operate lever (2) several times.
NOTE
Grease will appear under valve (7) when
air is removed.
Fig. 5
5 Close valve (7).
6 Operate lever (2) several times until
grease is being pumped from coupler (9).
NOTE
If grease is not being pumped from
coupler (9) force prime as follows.

Force prime

1 Pull follower rod (12) out and twist
T-handle (1) of follower rod (12) 90° to
latch onto grease follower (10 ).
2 Open valve (7).
3 Push on T-handle (1) of follower rod (12)
until grease appears from valve (7).
4 Close valve (7).
5 Rotate follower rod (12) to unlatch from
grease follower (10).
6 Push follower rod (12) into cylinder (6).
7 Operate lever (2) several times until
grease is dispensed from coupler (9).
5
6
12
7
9
15
Fig. 6