III. Technology Parameter
Voltage................................... AC220~240V 50Hz (110V-120V 60Hz, can be select)
Power................................................................................................................... 35W
Fuse: .................................................................................................... F1A, 250VAC
LED lamp: ................................................................................... 6X3W (R2. G2. B2)
Packing Size ................................................................................... 290×290×380mm
N/W ...................................................................................................................... 3Kg
G/W................................................................................................................... 3.6Kg
Installation
Install/replace LED lamp
First, after unscrewed the screw at the head of shell and then pull out it. You can see the LED. If found the LED
are not bright, then replace them. Installation method is just the opposite.
Unscrewed the
screws
Warning
1: The light power supply must be disconnected when replacement of the LED does not bright
2: you can repair the light before you must use a thermostat with anti-static electric iron, and wear anti-static rings
2. Power supply, wire Connection
Using a dedicated plug to connect the LED mini mushroom light and power. LED mini mushroom should pay
attention to whether the voltage and frequency between signs and on the power supply are the same or not.
Suggested that each light has a separate power supply switch, this can be turned on or off at random for each
LED mini mushroom. The LED mini mushroom selection of input voltage and frequency parameters as follows:
Voltage
AC220V 240V
Voltage
AC110V 240V
If the power cable is damaged, please contact the area agents or ask professional to replace; please use the
same specification cable when you replace the power cable.
Tip: When connecting the power, ground wire must (yellow / green color wire) safety grounding, electrical
installation must comply with all relevant standards.
3. Fixed installation of lighting (including light hook and safety rope how to use)
Before positioned the light, ensure the stability of the installation site. In the
reverse hanging installation, use two sets of M10 bolts with a professional big
hook, link the hanging screw hole on the bottom of the light, must be ensure that
the light will not fell down from support rack, through the support rack and light
hand use the safety rope for auxiliary lifting handle to ensure safety, to prevent
the light falling and sliding. Light in the installation, the bottom prohibit
pedestrians. Safety rope regularly checked whether there is wear and tear,
whether there is loose hook. The manufacturer does not take any responsibility if
the light falling because hanging installation is not stable.
Warning
1. Hook use only for light lifting.
2. Hook as a handle move the light to prohibit, carrying, please use the handle.
Frequency
Frequency
Hook installation
3
6LED lamp
50Hz
60Hz
© Copyright Lotronic 2009