Some of our products have emergency draining hose and some
does not have. Follow the steps below to discharge the water.
Discharging the water when the product has an emergency
draining hose:
Pull the emergency draining hose out from its seat Place a large
container at the end of the hose. Drain the water into the container
by pulling out the plug at the end of the hose. When the container
is full, block the inlet of the hose by replacing the plug. After the
container is emptied, repeat the above procedure to drain the water
in the machine completely. When draining of water is finished,
close the end by the plug again and fix the hose in its place. Turn
the pump filter to take it out.
Discharging the water when the product does not have an
emergency draining hose:
Place a large container in front of the filter to catch water from the
filter. Loosen pump filter (anticlockwise) until water starts to flow.
Fill the flowing water into the container you have placed in front of
the filter. Always keep a piece of cloth handy to absorb any spilled
water. When the water inside the machine is finished, take out the
filter completely by turning it. Clean any residues inside the filter as
well as fibers, if any, around the pump impeller region. Install the
filter.
If your product has a water jet feature, be sure to fit the
A
filter into its housing in the pump. Never force the filter
while installing it into its housing. Seat the filter into its place
completely. Otherwise, water may leak from the filter cap.
If the filter cap is composed of two pieces, close the filter cap by
pressing on the tab. If it is one piece, seat the tabs in the lower part
into their places first, and then press the upper part to close.
51
EN