ZWILLING J.A. Henckels FRESH & SAVE VACUUM PUMP Manuel D'utilisation page 39

Troubleshooting
Problem
The pump stops during the vacuum sealing process and does not turn back on.
Remedy
• The pump sucked in liquids during the vacuum sealing process. Do not turn the pump upside
down. Shake the pump slightly to remove any liquid. Make sure the pump and the charging
station are completely dry. Plug the pump into the charging station for one second to reset,
then remove it and push the On/Off button. Additional liquids may drip out. Repeat this
process if the pump stops again.
For more information on the products, visit our FAQ page at:
http://www.zwilling.com/fresh-and-save-faq.html
www.zwilling.com
EN
39