Rowenta DA1511 Mode D'emploi page 8

Problems
and possible causes
• The temperature selected is too low.
• The steam control is set on OFF.
• There is no water in the tank.
Water is dripping from the holes in the soleplate
• You have been using the burst of
steam button too often.
• Steam is used before the iron is
hot enough.
• The iron is stored with water in
th tank.
• The problem persists.
HELPLINE:
if you have any product problems or queries, please contact our
Customer Relations Team first for expert help and advice:
or consult our website - www.rowenta.co.uk
Your iron produces little or no steam
0845 602 1454 - UK
(01) 677 4003 - Ireland
Solutions
Set the temperature control on •••
Switch the steam control to ON.
Fill the water tank.
Wait a few seconds between each
shot.
Set the thermostat within the
coloured steam zone and wait until
the iron is hot (approx. 2 min.).
Empty the tank before storing the
iron and set the steam control to
OFF
Take your iron to an Approved
Service Centre.
8