Marmitek SD90 Mode D'emploi page 7

11 RESET TO THE FACTORY SETTINGS
If the SD90 smoke alarm does not function as you expected, or if you made a mistake during
programming, it is possible to reset the smoke alarm to the original factory settings. Follow these
instructions to reset the SD90:
1. Keep the Test button pressed (1) and press the Reset button (4) for a short period. The yellow LED (5)
will light up.
2. Let go of the Test button. The yellow LED will go out. Wait 3 seconds and go to step 3.
3. Press the Test button once. The yellow LED will light up when you press the Test button. Let go of the
Test button.
4. Wait until the yellow LED starts blinking again
5. Press the Test button once more. The yellow LED will light up when you press the Test button
6. Wait 20 seconds. The yellow LED will light up a number of times during the 20 seconds.
7. The smoke alarm has now been reset to the factory settings
☺ For an extra check you can press the Reset button once. The yellow LED should blink twice.
12 CHANGING THE ADDRESS OF THE SMOKE ALARM
Only change the address when your neighbours also use a Marmitek security system with SD90 smoke
alarms.
Your smoke alarm uses Address 1 as standard. You can change this address to address 2 .. 15. NEVER USE
ADDRESS 16 (this is a special function for advanced use).
Changing the address:
1. Keep the Test button pressed (1) and press the Reset button (4) for a short period. The yellow LED (5)
will light up.
2. Let go of the Test button. The yellow LED will go out. Wait 3 seconds and go to step 3.
3. Now enter the new address, for example, address 5.
4. Press the Test button five times. The yellow LED will light up every time you press the Test button.
5. Wait 20 seconds. The yellow LED will light up a number of times during the 20 seconds.
6. The address has now been changed.
7. You now have to (re)register your smoke alarm with your system. Press the Test button to see if
everything is working correctly. Your Marmitek system should now produce an alarm.
13 FREQUENTLY ASKED QUESTIONS
Question: Does the siren of the smoke detector also go off if an alarm is triggered?
Answer: No. The siren in the smoke detector cannot be triggered via the alarm system. It will
only go off when it detects fire/smoke.
Question: How many SD90 smoke detectors can I register?
Answer: Every SD90 is registered at the same address. There is no maximum number of smoke detectors.
Question: Is it possible to switch off the audio alarm signal that indicates the battery is almost empty?
Answer: No, because of safety considerations this signal cannot be switched off.
Question: Does every SD90 take up the place of a remote control when it is registered?
Answer: No, only the first SD90 that you registered takes the place of a remote control.
SD90
7