Sc2200, Sc2700, Sc2800, Protector; Registering The Smoke Detector With The Base Station Of The Type Homeguard Ms8000; What Happens When The Alarm Goes Off; Changing The Battery - Marmitek SD90 Mode D'emploi

3. When the PIN code has been entered correctly, the word 'INSTALL' will show up on the display.
4. Press OK.
5. Press the Test button (1) on the smoke alarm until the smoke alarm emits an audio signal. The console
will respond with a beep. The display will read "RMOT x SET".
6. Even If you are using more than one smoke detector you only have to register the first one.
7. Press CLEAR to go back to the main menu. Press CLEAR again to quit the menu.
7 REGISTERING THE SMOKE DETECTOR WITH THE BASE STATIONS
OF THE TYPES MS9470, MS9770, MS9970, SC2200, SC2700,
SC2800, PROTECTOR 28
Carry out the following steps:
1. Open the lid on the right side of your security system's base station.
2. Set the mode switch to the INSTALL position. All indicators of occupied zones will come on.
3. Press the Test button on the smoke alarm (1) until the alarm emits an audio signal. Your console will
respond with a beep.
4. Even If you are using more than one smoke detector you only have to register the first one.
5. Reset the mode switch to the RUN1 or RUN2 position. Zone indicators will go off.
8 REGISTERING THE SMOKE DETECTOR WITH THE BASE STATION OF
THE TYPE HOMEGUARD MS8000
Carry out the following steps:
(Every time you press a key you will hear a short confirmation beep)
1. Open the front lid of the HomeGuard MS8000.
2. Enter your current PIN. (Personal Identification Number) If you have never changed this code before,
the factory default code is [0000]. You will hear three high tones and one low tone as a confirmation.
The green indicator will start flashing.
3. Press "1" on the keyboard of the HomeGuard MS8000: one high tone is given to confirm.
4. Press the Test button on the smoke alarm (1) until the alarm emits an audio signal.
5. Even if you are using more than one smoke detector you only have to register the first one.
6. Press any button on your HomeGuard MS8000 keyboard to finalize the registration procedure. One
short low tone will be given and the green indicator stops flashing.

9 WHAT HAPPENS WHEN THE ALARM GOES OFF?

In the event of a fire, the smoke alarm will send an alarm signal to the Marmitek security system. It does
not matter if the console is switched on or off. The alarm will work in both instances.
The security system will call the pre-programmed telephone numbers, the alarm will go off (with or without
a siren, depending on the settings) and the lights will be turned on (this will not occur with HomeGuard).
You can test the system by keeping the Test button on the smoke alarm (1) pressed for more than 5 seconds.

10 CHANGING THE BATTERY

When the battery is almost empty, the SD90 will emit a short beep every 30 seconds. If this occurs,
immediately replace the battery. If you fail to do this, there is a risk that there will be no signal in case of a fire.
The SD90 settings will not be affected when changing the battery.
IMPORTANT: AFTER CHANGING THE BATTERY, PRESS THE RESET BUTTON ONCE
To ACTIVATE THE SMOKE ALARM!
6 MARMITEK