Installation; Preparing For Use; Registering The Smoke Detector With The Sc9000 Base Station Of The Safeguard / Totalguard - Marmitek SD90 Mode D'emploi

the SD90. The Marmitek security system should now be triggered and will dial the preprogrammed
telephone numbers.
In the case of range problems, choose a different location for your SD90 smoke detector.
Moving the SD90 just a few centimetres can make a big difference in range.
To avoid false alarms, do not install the SD90 smoke detector in your kitchen, garage, in dusty
places, in places with a higher than average air flow (near ventilation, open windows), near
metal and in places where the temperature is below 10°C or above 37°C.

4 INSTALLATION

Please follow these steps to install the Marmitek smoke detector:
• Do not insert the battery at this stage (9V). Please follow the steps of the next chapter before you
insert the battery. The smoke detector will not operate until you insert the battery properly.
• Remove the mounting bracket from your unit by rotating it counter-clockwise.
• In each of the keyhole slots, draw a mark on the wall or ceiling to locate a mounting plug and screw.
• Remove the bracket.
• Drill two holes at the marks and insert plastic wall plugs. Ensure that the detector does not get any
plaster dust on it when you drill the holes for mounting.
• Attach the bracket to the wall using the two screws and plastic wall plugs (supplied)
• Line up the slot of the bracket and the detector. Push the detector onto the mounting bracket and
turn it clockwise to fix it into place. Pull outward on the detector to make sure it is securely attached to
the mounting bracket.

5 PREPARING FOR USE

The factory settings of the SD90 mean that an alarm message is sent to your Marmitek security system,
even when your system is not activated.
☺ Optional. You can also have the smoke alarm configured to be registered as a "sensor" with your
Marmitek system (advanced use). This offers you two extra options.
When there is an alarm, you can see which sensor triggered the alarm.
A message will be displayed on your console when the battery is running out of power.
If you want to use the advanced options of the SD90, you can download the instruction manual for
"advanced use of the SD90" from www.marmitek.com (this can be found in the SD90 product
information, click the link directions for use). The advanced options do not work with HomeGuard.
Activating the sensor:
1. Connect the battery
2. Press the Reset button for a short period (4)
3. The yellow LED will blink twice
☺ If the yellow LED blinks more than twice, reset the smoke alarm to the factory setting. (See chapter 11.)
6 REGISTERING THE SMOKE DETECTOR WITH THE SC9000 BASE
STATION OF THE SAFEGUARD / TOTALGUARD
Carry out the following steps:
1. To access the menu, press the menu
2. Enter your 4-digit PIN code (factory setting 0000). For every digit entered, a * will appear on the display.
SD90
or menu button. The display will now read 'ENTER PIN'.
5