Storage; Preparing The Machine For Storage; Folding The Handle - Toro Recycler 20995 Manuel De L'opérateur

Storage

Preparing the Machine for
Storage
WARNING
Gasoline vapors can explode.
• Do not store gasoline more than 30 days.
• Do not store the machine in an enclosure near
an open flame.
• Allow the engine to cool before storing it.
1. On the last refueling of the year, add fuel stabilizer to
the fuel as directed by the engine manufacturer.
2. Run the machine until the engine stops from running
out of fuel.
3. Prime the engine and start it again.
4. Allow the engine to run until it stops. When you can
no longer start the engine, it is sufficiently dry.
5. Disconnect the wire from the spark plug.
6. Remove the spark plug, add 30 ml (1 oz) of oil through
the spark plug hole, and pull the starter rope slowly
several times to distribute oil throughout the cylinder
to prevent cylinder corrosion during the off-season.
7. Loosely install the spark plug.
8. Tighten all nuts, bolts, and screws.

Folding the Handle

Model 20995 only
WARNING
Folding or unfolding the handle improperly can
damage the cables, causing an unsafe operating
condition.
• Do not damage the cables when folding or
unfolding the handle.
• If a cable is damaged, contact an Authorized
Service Dealer.
1. Loosen the handle knobs until you can move the upper
handle freely (Figure 55).
2. Fold the upper handle forward as shown in Figure 56.
3. To unfold the handle, reverse the steps above.
Folding the Handle
Model 20996 only
Upright Position
1. Step on the foot pedal and hold it down (Figure 57).
21
Figure 55
Figure 56
Figure 57