Homa SaniQ one Manuel D'instructions Original page 29

Resolve blockages in the cutting unit
Adjust the voltage and pull the main plug. Then, open the
lifting unit. To do this remove the four plastic caps in the
lid of the lifting system. Among them is a screw that you
need to now screw out. Remove the cover then upwards.
Now as shown using a screwdriver turn the motor shaft
until the blockage is solved.
Further steps for troubleshooting
If the items listed here do not help you rectify the fault,
contact our customer service. They can help you as fol-
lows:
• Telephone or written help from customer service
• On-site support from customer service
• Checking and repairing the machine at the factory
Note that you may be charged for some services provided
by our customer support. Customer service will provide
you with details on this.
EngliSH | 29