Foppapedretti TUO Notice D'utilisation page 19

All manuals and user guides at all-guides.com
GB
USE
REVERSIBLE SEAT (fig.29a/b)
Press buttons "A" on both sides and remove the seat by lifting it.
Position the seat so that it is forward facing or parent-facing.
Replace the seat on the chassis of the pushchair, see the paragraph "fitting the seat" for correct
assembly.
ADJUSTING THE FOOTREST (fig.30)
Press buttons "A" and adjust the footrest in the required position.
ADJUSTING THE HOOD (fig.31 - fig.32)
Extend the hood according to requirements to protect baby from the sun.
Note: babies' skin is very delicate. NEVER leave baby under direct sunlight. Always make sure that
the hood has been adjusted correctly.
Remove the rear part of the hood to use it as a parasol.
SHOPPING BASKET (fig.33)
The basket is fitted on the lower part of the chassis by means of press fasteners. To remove it,
open the press fasteners.
The basket can be used to carry a maximum weight of 5 kg.
The basket should be emptied before folding the pushchair.
FOLDING THE PUSHCHAIR (fig.34a/b/c/d/e/f - fig.35)
Before folding the pushchair, make sure that:
• The seat is forward facing
• The backrest is adjusted in the upright position
• The hood is folded
• The front wheels are locked
Press both the buttons at the side of the handlebar and turn the handlebar completely downwards,
so it is in the position with the fastener open.
Hold the handle at the back of the pushchair and lift it upwards to fold the pushchair.
Make sure that both the closing levers on both sides of the chassis have been fastened.
Note: It is NOT possible to close the pushchair with the travel system accessories, the infant car
seat and carrycot, fitted on the chassis
USING THE TRAVEL SYSTEM ACCESSORIES
The TUO pushchair can be used with the following travel system accessories, TUO carrycot and
TUO infant car seat.
Remove the seat from the chassis (see the paragraph "Fitting the seat").
FITTING THE RIGHT AND LEFT ADAPTER (fig.36 - fig.37a/b)
Line up and insert the right and left adapter in the slots provided on the chassis of the pushchair.
Press until a click is heard indicating that the adapter has been secured correctly.
WARNING: Before use, always make sure that both the adapters have been secured correctly to the
chassis. When lifted they must not detach from the chassis.
REMOVING THE ADAPTERS(fig.38): press button "A" to remove the adapter.
TUO 19