Foppapedretti TUO Notice D'utilisation page 18

All manuals and user guides at all-guides.com
GB
TO INSTALL
Secure the footmuff to the chassis of the pushchair using the press fasteners.
FITTING THE PUSHCHAIR RAINCOVER (fig.19)
Fit the raincover over the hood.
Fasten the edges at the back of the raincover using the Velcro tabs.
Fasten the front of the raincover to the chassis of the pushchair using the Velcro tabs.
USE
HOW TO OPEN THE PUSHCHAIR (fig.20 - fig.21a/b/c)
Press both the buttons at the side of handlebar "A" and turn the handlebar into positions 1, 2 or 3.
A click will indicate that it has been fastened.
Press both the levers (closing hook) "B" and lift the chassis upwards, at the same time press the
rear locking pedal "C" downwards with the foot, until it is completely open.
Make sure the pushchair has been opened correctly by pressing the handlebar at the sides, the
chassis should remain locked in place. If one side has not been locked correctly, grip the handlebar
on the side that has not been fastened and pull upwards to fasten the chassis correctly.
PARKING BRAKE
To apply the brake (fig.22): Press the brake lever, push the pushchair forward gently to ensure the
brake has been applied correctly.
To release the brake (fig.23): lift the lever.
TO ADJUST THE HANDLEBAR (fig.24)
Lift the regulating lever located behind the backrest and recline the backrest to the required
position. Release the lever and make sure the backrest is secured in position.
TO REGULATE THE BACKREST (fig.25)
Lift the regulating lever located behind the backrest and recline the backrest to the required
position. Release the lever and make sure the backrest is secured in position.
WARNING (fig.25a): For babies under 6 months of age, the backrest must only be in the fully
reclined, horizontal position at all times.
SAFETY HARNESS
Apply the brake before placing your baby in the pushchair.
Release the buckle (fig.26a/b): press button "A" and remove the components
Fasten the buckle (fig.27a/b/c): by inserting part A in part B, a click will indicate that it has been
fastened correctly.
If baby is less than 6 months old, the harness belts must first be inserted through the lower slots
and then through the rings of the harness regulating buckle (fig.28a/b/c).
IMPORTANT: For babies under 6 months of age, the backrest must only be regulated in the fully
reclined, horizontal position at all times.
WARNING: Never use the crutch strap without the lap belt.
WARNING: The lap belt is provided with 2 side rings to be used for additional belts in compliance
with the standard BS 6684.
TUO 18