Publicité
M1.1.IDH110.NLFREN 20082018
EN
Operation panel instructions：
4 Operation panel
1
2
1. Power light: This light on when the machine is charging.
1. Power light. This light on when the machine is charging.
2. Over temperature indicator: The machine will stop working when inside over heat and the temperature indicator
starting.
3. Time increase and decrease: For setting the working time, with memory function.
2.Over temperature indicator: The machine will stop working when inside over heat and
the temperature indicator starting.
Time setting range: 0.2 - 4 s. that is automatic working mode (machine will keep working and will immediately stop
working when the scheduled time arrived or sudden halt occurred). FF means manual mode ( machine keep working till
power off) Every time you press the switch after setting, it will be recorded. Each time you turn on the machine will see the
3.Time increase and decrease: For setting the working time, with memory function.
adjusted time you set last time.
Time setting range: 0.2-4s that is automatic working mode(machine will keep
4. Power increase and decrease: Adjust the working power, with memory function.
working and will immediately stop working when the scheduled time arrived
or sudden halt accured) FF means manual mode ( machine keep working till
Power range from 20% to FF (100%). Please set appropriate power for heating according to dent situation avoid to be
power off) Every time you press the switch after setting, it will be recorded. Each time
burnt out.
you turn on the machine will see the adjusted time you set last time.
5. LCD conveniently shows working time and working power. When pressing the starting key, there are dynamic pictures
indicate the machine is under heating with no protection.
4.Power increase and decrease: Adjust the working power, with memory function.
Power range from 20% to FF (100%). Please set appropriate power for heating
5 Troubleshooting
according to dent situation avoid to be burnt out.
•
Follow below instructions: Firstly unplug the machine and open the case, check the fuse is burnt out or not, then check
5.LCD conveniently shows working time and working power. When pressing the starting key,
the power supply to see if it is well-connected. If any help needed, please contact our after-sales department.
there are dynamic pictures indicate the machine is under heating with no protection.
•
Overheat warning: It is a normal phenomenon that the over-heat warning arising after a long working time. In this
case, put the machine at a ventilated area. Don't use it until cooling down. If the warning appears as soon as you turn on
the machine, please report to our after-sales department.
•
No action: LCD shows the machine is under working, but it actually not. If in that case, follow the instructions to open the
case and check the connection, reinsert the plug. If the LCD no function or working condition can not be recognized, please
contact our after sales department.
3
4
5
7
Publicité
