Carrier 80HMA Mode D'emploi page 27

Variable table
Nr.
Name
Par.
Use Days button to select the
sub-parameter
Home antifreeze option
0 : Disable
1 : Enable
Allow user to change
setpoint/schedule settings for
the zone.
11 User Config
0. Allowed
1. Not Allowed
Water Pump (if mapped)
behaviour
0. Water pump does not stop
when room setpoint is reached
1. Water pump stops when
room setpoint is reached
Antifreeze
12 Home antifreeze setpoint (°C)
Setpoint
Too Cold Too Cold Protection Setpoint
13
Setpoint (°C)
Too Warm Too Warm Protection Setpoint
14
Setpoint (°C)
Room Hysteresis on Room
15
Hysteresis Temperature (°C)
Adjust Heating Delta temperature applied to
16 Climatic Curve the maximum temperature of
(Ref. X in pic. 6) heating climatic curve (°C)
Adjust Cooling Delta temperature applied to
17 Climatic Curve the minimum temperature of
(Ref. Y in pic. 6) cooling climatic curve (°C)
Adjust Room Delta to apply to Room
18 Sensor Temperature read by user
Temperature Interface (°C)
Use Days button to select the
sub-parameter
If Master Board, show the
temperatures of:
Water in the Comfort Module
tank (°C)
Leaving water to Comfort
Module (°C)
Sanitary Water (°C)
Outdoor air, read by the
19 Temperatures
Comfort Module sensor (°C)
If Slave Board, show the
temperatures of:
Water in the disconnecting
water tank (°C)
Leaving temperature of the
zone (°C)
Sanitary Water (°C)
Outdoor air, read by the
Comfort Module sensor (°C)
Dehumidifier Humidity setpoint to start the
20
treshold Dehumidifier (%Rh)
Humidifier Humidity setpoint to start the
21
treshold Humidifier (%Rh)
Description Master
LEVEL 1 and 2
x
x
x
x
x
x
x
x
x
x
x
Available on
User Heat
Slave Pool
Interface Pump
x x
x x
x
x
x x
x x
x x
x x
x x
x x
x x
RANGE
MIN MAX DEFAULT
1
0
0
6 12 6
0 40 15
0 40 30
0,1 2 0,5
-5 5 0
-5 5 0
-5 5 0
- - -
20 100 60
20 100 40
15
80HMA