Introduction; General Information; Main Overview; Comfort Module Identification - Carrier 80HMA Mode D'emploi

Introduction

General information

The Comfort Module manages the water distribution
to achieve the best comfort with the lowest power
consumption. It drives the heat pump matched and the
hydronic items connected.
It's used in combination with floor circuit, fan coil units,
radiators and hot water tanks for sanitary use.

Main overview

The Comfort Module includes: 10 litres tank with electrical
heaters or interface for external heat source, security
devices (flow switch, pressure switch, thermal fuse on
electrical heater), control box with fully customizable input/
output and the main user interface (detachable).
It's possible to install an addition water pump (Kit Pump
code 80HMA-9003), to increase the head pressure to the
system, or an heat exchanger (Kit BPHE 8kw code 80HMA-

Comfort Module identification

80HMA-M00 Comfort Module with backup boiler connection
80HMA-M03 Comfort Module with 3kW, 1ph electric heater backup (1 heating step)
80HMA-M06 Comfort Module with 6kW, 1ph electric heater backup (3 heating steps)
80HMA-T06 Comfort Module with 6kW, 3ph electric heater backup (3 heating steps)
80HMA-T09 Comfort Module with 9kW, 3ph electric heater backup (3 heating steps)
2
80HMA
It can drive different models of heat pump: up to 8 Carrier
inverter heat pumps 30AWH___HC series (or newer), Carrier
fixed speed heat pumps or any heat pump operated by
dry-contacts.
Moreover, it can control additional heat source as a gas/
solar boiler (M0 version) or the integrated electrical heaters
(M3, M6, T6, T9 versions).
9004 or Kit BPHE 16kW code 80HMA-9005) to separate the
external hydraulic circuit (primary loop) from the internal
one (secondary loop).
It's possible to add the 2 zone kit (80HMA-9001) to manage
2 different zones, a sanitary water valve (80AW9023) and
sanitary tank (60STS/60STD series) to produce sanitary hot
water, a pool valve plus Pool Kit (code 80HMA-9002) to heat
a swimming pool and an addition user interface to place in
the room to control.