Mestra TEIDE 1 Mode D'emploi page 8

English
Operation
 Press the main switch placed in the back side.
 Slowly move the unit's regulator (C) clockwise and
check that the oscillation rate gradually increases. Set
the regulator to a suitable amplitude for the operation.
 After a short time, once the mixture is properly
compacted, switch the unit off using the right switch.
 When not using the vibrator for a while, disconnect it
from the network acting on the rear main switch.
Maintenance and cleaning
To ensure a long, trouble-free service life and
performance of the unit, we recommend as follows:
 After using the unit, always clean away any splashes
of mixture before they dry.
 As a precaution, always disconnect the unit from the
mains before cleaning it.
 Regularly check the suction caps (D).
 Use only original spare parts supplied by the
manufacturer.
Precautions
 Before connecting the unit to the power source, make
sure the voltage is correct (grounded 230 V, 50/60
Hz).
 The cable may only be replaced by one with the same
characteristics as supplied by the manufacturer.Do not
use the unit in wet places or close to heat sources.
 Do not place easily broken containers or other objects
on the vibration platform.
 Do not allow children or unskilled personnel to handle
the unit.
 Do not pull, twist or bend the mains cable excessively.
 Before cleaning the unit, ensure that it is unplugged.
 Never immerse the unit in liquid when cleaning it.
 Do not place hot containers or objects on the vibration
platform, as this may damage the rubber.
 Do not remove the vibration platform cover.
10
OFF
Vibration power
Technical characteristics
Power supply:
Dimensions:
Consumption:
Fuse:
Sound power:
Weight:
Vibrations p. m.:
Declaration of conformity UE
The firm Talleres Mestraitua S.L.
with social address: Txori-erri Etorbidea, 60
48150 Sondika - Bilbao - Spain
Hereby declares that the product
Electro vibrator Teide 1, R-080164
Meets the requirements set out in the following
directives:
2014/35/UE (low tension)
2014/30/UE (electro magnetic compatibility)
2006/42/CE (machinery safety)
230 V, 50/60 Hz
197 x 265 x 227 mm
240 W
Glass 9 A, 110-240 V
< 70 dBA
5,5 kg
3000
Ignacio Mestraitua
Managing Director
Sondika, 2017-03-01