Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
If the machine oil level is below the bottom of the machine oil ruler, fill the recommended
machine oil into the fuel-filling mouth.
If the engine runs while oil is in shortage, it can be seriously damaged.
14.1.7 Oil change
The disposal of the oil must meet the regulations. Make sure that no oil is spilt
during the oil change (using of suitable container; if oil drops in machine, clean
it properly and dispose the cleaning tool correctly). Do not dispose of the oil in
residual waste.
Changing the oil is easier when the engine is still warm.
Remove the oil outlet screw (A) and the seal ring (B).
Drain the dirty oil into a suitable container.
Fix the oil outlet screw again.
Fill in new engine oil.
Check the engine oil level with the dipstick (C).
If the level is correct, reinsert the dipstick again.
14.1.8 Refuel
Each normal petrol (unleaded petrol) with octane index (ROZ) of 95 can be used. Never use a mix of oil
and petrol or dirty petrol. Avoid infiltration of the gasoline tank by water, dust or dirt.
It is not recommended to use alternative for gasoline, because this can cause damage of parts of
the gasoline system.
14.1.9 Cleaning
Clean the machine and the working attachment from dirt.
Clean the machine housing with a wet cloth and a mild cleaning solution.
Put on all coatless flats a thin coat of oil.
The usage of solvents, aggressive chemicals or scouring agents damages the machine
housing.
14.1.10
Storage
If the machine is stored for longer than 30 days:
Run engine until fuel tank is empty and engine stops.
•
Let the machine cool down.
•
Clean the machine and dry.
•
Empty Tank and carburetor completely, avoid fuel spillage.
Remove the spark plug cap.
ZIPPER MASCHINEN GmbH
www.Zipper-Maschinen.at
ZI-HAEK4000
WARNING
NOTICE
NOTICE
NOTICE
MAINTENANCE
C
B
A
28
Publicité
Table des Matières
