SKF 729101 Mode D'emploi page 11

Push the gauge adapter nipple into the top slot of
the adapter block.
Note: to avoid misalignment the O-ring has to be
located on the flat quadrangular of the gauge
nipple.
The following operation should be done carefully.
The illustration shows how the seal will be
achieved. Screw the high pressure pipe nipple into
the back of the adapter block, while gently moving
the gauge adapter nipple in order to secure the
correct position of the high pressure sealing area.
Make sure all parts are properly aligned. Failure in
doing so will prevent proper sealing and will cause
leakage.
Thanks to the special design of the components an
effective sealing can be achieved with moderate
tightening torque.
SKF 729101
E
D
A Gauge nipple O-ring
226402-2
B Oil injector 226400
C Gauge adapter nipple
226402-1
D Adapter block 226402
E High pressure pipe
A
B
C
11