Installing Mp Load Bars - Tru-Test MP Serie Mode D'emploi

Installing MP load bars

Caution
- Dropping the platform or crate with load bars fitted, or dropping the platform onto the load bars can damage
the load bars.
- Do not weld the platform or crate while the load bars are attached.
Select a convenient position for the platform in a race or alleyway which is only slightly wider approximately
50 mm (2") than the platform and which has suitable entry and exit gates. Or select a convenient position for
the crate.
Select a firm and level site free of any obstacles, which may come into contact with the load bar assembly and
cause binding. It should be cleared of stones and dung if possible prior to installation. A concrete pad is ideal.
1 Carefully position each load bar under the platform or crate and ensure that the mounting holes in the
platform line up with those in the load bars.
2 Bolt the platform or crate to the load bars using the four M10x40 bolts supplied with your system. If
required, fit packing under the rubber feet to ensure that the installation is level and to prevent the platform
from rocking. Do not attempt to eliminate rocking by removing or loosening any of the rubber feet.
3 See Preventing platform movement on page 6 if platform restraint required. Otherwise, the load bar
assembly is ready for testing and use. See Testing on page 10.
5