Instructions; E12; Starting Instructions; Shut Down Instructions - Mosquito Magnet PIONEER Mode D'emploi

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Starting Instructions

It is recommended that you read the entire manual
before starting the Mosquito Magnet
1. Insert co-formulant cartridge as instructed on pack.
2. Connect regulator to propane tank (see page 11).
3. Plug power connector into the trap.
4. Plug AC adapter into electrical socket. (To avoid the
risk of electrical shock, connect only to properly
grounded outlets.) Adapter unit is not intended to be
mounted.
5. Slowly turn propane tank valve on.
6. Turn rocker switch to "on" position.
7. The red light on the switch will flash for up to 20
minutes (warm up phase).
8. Once the light stops flashing and is solid, the Mosquito
Magnet
®
is fully operational.
NOTE:
Should you experience an interruption of power,
be sure to restart trap.

Shut Down Instructions

To shut down the Mosquito Magnet
on the propane tank and switch to the "off" position.

When Not In Use

If the unit is not in use, the gas must be turned off at the
supply cylinder. Storage of this unit indoors is permissible only
if the cylinder is disconnected and removed. Cylinders must
be stored outdoors, out of reach of children and must not be
stored in a building, garage or any other enclosed area.

End of Season Storage

Push ON/OFF switch to OFF position to shut down the
trap. The LED light will go out and the fan will continue
running until trap is cool. Close the propane tank valve and
disconnect regulator.
Any open Mosquito Magnet
discarded. See co-formulant label for disposal instructions. The
bug bag should also be discarded prior to storing the trap.
STORAGE:
The trap should be stored indoors in a garage
or shed in the off-season. Cover trumpet to prohibit insects
from nesting. Cover unit with a tarp and secure tightly at the
bottom to keep out dust, spider webs and other debris.

E12

Instructions

**READ MANUAL BEFORE STARTING**
®
trap.
®
simply close the valve
®
cartridge should be removed and
For Best Results (unit must run for 24 hours/day)
• Your trap will begin capturing immediately with
significant reduction in the mosquito population in
7-10 days. Allow 4 weeks to significantly reduce the
mosquito population in your yard.
• Allow trap to cool for 5 minutes before re-start.
• Never spray insecticide in or around trap.
• Trap can be left running in the rain.
• If using lime or fertilizer compounds, be sure to shut
down the trap first to prevent dust or fine mist from
being drawn into trap and clogging bug bag.
Warning: Improper installation, adjustment, alteration,
service or maintenance can cause injury or property
damage. Read the installation, operating and maintenance
instructions thoroughly before installing or servicing this
equipment.
Caution: The gas pressure regulator provided with this
appliance must be used. This regulator is set for an outlet
pressure 11.0 in. water column.
The gas supply must be turned off at the LP-Gas supply
cylinder when this appliance is not in use.

Publicité

Table des Matières
loading

Table des Matières