Maintenance And Cleaning - Blumfeldt Dark Wave Stand Mode D'emploi

MAINTENANCE AND CLEANING

Attention! Careful and regular maintenance and cleaning of infrared Heater is
required to attain a long and efficient operation of your appliance.
1. Check the cleanliness of the reflector and IR-filament at least once a
month. If necessary, apply cleaning and maintenance instructions.
2. The number of checks may be increased considering the amount of the
dust in the environment.
3. Check the deformation of the reflector, wire and frame visually while
cleaning the appliance. In case of any deformation, consult a qualified
technician.
4. Check the power cable and plug visually while cleaning the appliance. In
case of any deformation, consult a qualified technician.
5. It is recommended to change the reflector every 2 years for more efficient
operation
Cleaning
1. Unplug your power cable for your safety before cleaning your appliance.
2. Take out the front grid wire through the inlets on the frame using a slotted
screwdriver.
3. Make sure that the power is off for your safety. Power cable plug must be
unplugged.
4. The reflector and filament must be cleaned with a soft cloth, a smooth
brush or cool or dry air. The cloth may be damp but never too wet and the
cleaner should not include any chemical.
5. Refrain from using cleaning material likely to damage the reflector
(cleanser etc.).
6. Insert the wire grid using a slotted screwdriver.
EN
25