Blumfeldt Dark Wave Stand Mode D'emploi page 21

The following numbers refer to the numbering indicated in the scope of
delivery.
1. Place the 4 x feet (5) into the slots on the bottom of the base of the pole
(2).
2. Tighten pole (2) into the stand centre by turning the pre-attached stand
centre cover clockwise until tight.
3. Place the heater head (1) face down on a soft surface. Attach the 2 x
brackets(3) to the plates in the back of the heater (1) using 4 x bolts (A). Do
not over tighten at this stage so the brackets can easily slide in the groove
on the back of the heater head (1). English head (1) is lined up centrally.
4. Using the 2 x cogs (4) and 2 x washers (B) attach the heater head (1) to the
pole, adjust the brackets (3) and angle of the heater head (1) to position to
your desired angle and tighten the cogs (4).Tighten 4 x bolts (A) to secure.
5. Secure the cable to the pole (2) using the pre-attached cable clips.
The heater is now ready to use. Please see operation instruction. Ensure you
have read these instructions thoroughly prior to use.
Wall mounting
1. There are 4 brackets and fasteners used with the heater. Furthermore, in
the canal of back side of the heater there are 4 square fastener washers
25×25mm. Take the square washers(Figure 1)and fasten 2 brackets to the
canal of the backside of the heater by the help of screws(Figure 2) .
EN
21