Maintenance And Cleaning - Blumfeldt Dark Wave Mode D'emploi

EN
20

MAINTENANCE AND CLEANING

Attention! Careful and regular maintenance and cleaning of infrared Heater is
required to attain a long and efficient operation of your appliance.
1 Check the cleanliness of the reflector and IR-filament at least once a
month. If necessary, apply cleaning and maintenance instructions.
2 The number of checks may be increased considering the amount of the
dust in the environment.
3 Check the deformation of the reflector, wire and frame visually while
cleaning the appliance. In case of any deformation, consult a qualified
technician.
4 Check the power cable and plug visually while cleaning the appliance. In
case of any deformation, consult a qualified technician.
5 It is recommended to change the reflector every 2 years for more efficient
operation
Cleaning
1 Unplug your power cable for your safety before cleaning your appliance.
2 Take out the front grid wire through the inlets on the frame using a slotted
screwdriver.
3 Make sure that the power is off for your safety. Power cable plug must be
unplugged.
4 The reflector and filament must be cleaned with a soft cloth, a smooth
brush or cool or dry air. The cloth may be damp but never too wet and the
cleaner should not include any chemical.
5 Refrain from using cleaning material likely to damage the reflector
(cleanser etc.).
6 Insert the wire grid using a slotted screwdriver.