Quick Start - NEC MultiSync FP1375X Manuel D'utilisation

Quick Start

To attach the MultiSync
these instructions:
1. Turn off the power to your computer.
2. If necessary, install the display card into your system. For more information,
refer to the display card manual.
3. For the PC with Analog output: Connect the 15-pin mini D-SUB to DVI signal
cable to the connector of the display card in your system (Figure A.1).
For the PC with DVI digital output: Connect the DVI signal cable to the
connector of the display card in your system (Figure A.2). Tighten all screws.
For the Mac: Connect the MultiSync FP
included) to the monitor connector on the Macintosh (Figure B.1). Attach the
15-pin mini D-SUB end of the captive signal cable to the MultiSync FP
Macintosh cable adapter on the computer (Figure B.1). Tighten all screws.
NOTE: To obtain the MultiSync FP1375X Macintosh cable adapter, call
NEC-Mitsubishi Electronics Display of America, Inc. at (800) 820-1230.
4. For download information on the Windows
your MultiSync monitor, refer to the References section of this User's Manual.
5. Connect one end of the power cord to the MultiSync FP
other end to the power outlet (Figure C.1).
6. Turn on the monitor (Figure D.1) and the computer.
NOTE: If you have any problems, please refer to the Troubleshooting section of
this User's Manual.
DVI-A or 15-pin
Detachable
Signal Cable
USB
Cable
DVI-A or 15-pin
Figure A.1
® FP ™ monitor to your system, follow
1375X
1375X
®
mini D-SUB
Cable
mini D-SUB
3
Macintosh cable adapter (not
95/98/2000/Me INF file for
monitor and the
1375X
Detachable
DVI-D
Signal Cable
USB
DVI-D
Figure A.2
1375X