NEC MultiSync FP1375X Manuel D'utilisation page 10

Controls
–continued
EdgeLock Control: Operating your monitor at a non-standard timing may
™
cause images to appear darker than normal or have color distortion. Use of the
EdgeLock control will adjust images to their normal state.
VIDEO DETECT: Selects the method of video detection when more than one computer is connected.
NONE: The Monitor will not search the other video input port unless the monitor is
turned on.
FIRST DETECT: The video input has to be switched to "FIRST DETECT" mode. When
current video input signal is not present, then the monitor searches for a video signal
from the other video input port. If the video signal is present in the other port, then the
monitor switches the video source input port to the new found video source automati-
cally. The monitor will not look for other video signals while the current video source
is present.
LAST DETECT: The video input has to be switched to the "LAST DETECT" mode. When
the monitor is displaying a signal from the current source and a new secondary
source is supplied to the monitor, then the monitor will automatically switch to the
new video source. When current video input signal is not present, then the monitor
searches for a video signal from the other video input port. If the video signal is
present in the other port, then the monitor switches the video source input port to the
new found video source automatically.
DVI SELECTION: This function selects the DVI input mode. When the DVI selection has
been changed, you must restart your computer.
DIGITAL: DVI digital input is available.
ANALOG: DVI analog input is available.
Information
Display Mode: Indicates the current mode and frequency setting of the monitor.
Monitor Info: Indicates the model and serial numbers of your monitor.
Refresh Notifier: A message will advise you if the refresh rate of the signal being
applied to the monitor by the computer is too low. For further information, please
refer to your display card or system manual.
8