Receiver Installation - Spektrum AR6400LBL Guide De L'utilisateur

EN
AR6400LBL Features and Ports
Battery Input
Rudder (CH4)
Servo
Reversed Aileron (CH2)
or Aux1 (CH6)
Aileron (CH2)

Receiver Installation

We recommend using double-sided foam tape strips and/or minimal hot glue in the corners to
install your receiver in the fuselage. The servos must be in the appropriate position to attach to and
drive the elevator and rudder pushrods. Note: Installation will vary depending upon application.
Servos
The AR6400LBL incorporates integrated servos; optional specially designed servos are available
through Spektrum. NOTICE: Using any other servo(s) may cause damage to the receiver and/or
the servo and may void the warranty.
Installing and Plugging in the Optional Servos
Use double-sided foam tape strips and/or minimal hot glue to mount the servos in place. The servos
must be in the appropriate position to attach to the corresponding pushrods. Plug the servo leads into
the appropriate servo ports in the receiver noting the polarity of the servo connector. Installation will
vary depending on application.
Brushless
Motor Leads
Optional Servo (SPMAS2000/SPMAS2000L)
4
Elevator (CH3)
Servo
Antenna
X-Port (all 4 pins)
OR
Gear (CH5) (upper 3 pins)