Publicité
Les langues disponibles
Les langues disponibles
Work instructions
• Find out the correct tyre pressure before inflating a
tyre and do not exceed this value.
• Connect the valve adapter (4 )to the tyre inflation
valve. Turn the valve adapter by about half a turn.
2.
• Inflate a tyre in short bursts, checking the pressure
increase between the individual stages of inflation
using the pressure gauge (1).
• In order to inflate the tyre, press the operating
lever (3) all the way down. To reduce the tyre
pressure, press the operating lever (3) half-way.
• The general safety instructions in the safety infor-
mation section must also be followed.
Maintenance and cleaning
• Disconnect the device from the compressed air
supply during maintenance and cleaning work.
• Keep the device clean at all times.
• Follow the calibrating instructions.
Correct usage
The manual tyre inflator is a high quality
precision measuring instrument.
Correct usage is a prerequisite for a long
service life.
• After using the device, always hang it up using the
suspension lug (7) and do not leave the device on
the ground.
• Do not subject the manual tyre inflator to
mechanical loads, particularly the pressure gauge.
• Do not drive over or drop the device.
1.
The relevant national regulations apply. In Germany,
measuring devices for checking tyre pressures must
be calibrated as per the calibration law of
25th July 2013. The calibration is valid for two
years from the end of the calendar year in which the
measuring device was last calibrated. The responsi-
4
bility for calibrating lies with the person who uses
or provides the device.
We provide a warranty for this Würth device from
the date of purchase and in accordance with the
legal/country-specific regulations (proof of
purchase through invoice or delivery note). Damage
that has occurred will be corrected either by
replacement or by repair. Damage caused by
improper handling is not covered by the warranty.
Claims under warranty can only be accepted if the
device is returned fully assembled to a Würth
agency, your Würth sales representative or an
authorised Würth customer service workshop.
We reserve the right to make technical changes.
We accept no liability for printing errors.
EC Declaration of Conformity
We declare under our sole responsibility that this
product is in conformity with the following standards
or standardization documents:
2006/42/EG as EN 12100
Technical documentation with:
Adolf Würth GmbH & Co. KG
Reinhold-Würth-Straße 12–17,
74653 Künzelsau, GERMANY
Frank Wolpert
Head of Product-
management
Authorized Signatory
Künzelsau: 12. 10. 2016
Subject to change without notice
Calibration
Warranty
Dr.-Ing. Siegfried Beichter
Head of Quality
Authorized Signatory
5
Publicité
