Transportation; Standard Laser Alignment Unit; Battery; 21 9.2 Professional Laser Alignment Unit - Bosch RSCD 2100 Notice Originale

8.

Transportation

1. Position the mirror unit at a height of approx.
600 mm when moving the adjustment unit.
2. Screw in the positioning foot to provide a distance
of at least 1 cm to the surface of the floor.
3. Use the handle to push or pull the adjustment unit
forwards.
i
The adjustment unit can be steered easily by lifting
the handle slightly.
!
On inclined passageways or when when crossing
over uneven areas on floors, the adjustment unit
must be held additionally at the upper end of the
post to prevent tipping.
!
When moving, ensure that the mirror does not strike
furnishings, walls or door frames.
!
Risk of injury: The securing cable must be attached
while transporting/moving the unit.
Robert Bosch GmbH
Transportation | RSCD 2100 | 29 |en
9. Maintenance
9.1

Standard laser alignment unit

battery

1. Open the laser module housing (unscrew).
2. Replace the battery.
3. Close the laser module housing.
i
When replacing the battery, ensure that the laser modu-
le is not rotated in the mounting.
Abb. 18: Battery replacement
9.2 Professional laser alignment unit
battery
1. Open the laser box housing.
2. Replace the battery.
3. Close the laser box housing.
9.3 Securing cable for mirror unit
1. Check the condition of the expander.
2. Lowering check with determination of the final stop
position.
i
With the securing cable attached, it must not be
possible to lower the mirror unit below 400 mm.
!
The securing cable must be replaced if the above
items are considered critical by the operator.
|
1 690 386 085 2018-08-21