Bosch RSCD 2100 Notice Originale page 26

en | 26 | RSCD 2100 | Test sequence
2
Abb. 11: Moving upwards
1 Vertical release
2 Arrow mark for center of mirror points to height scale (units in
mm)
5. Rotate vertical release to the right.
2
Abb. 12: Moving downwards.
1 Vertical release
2 Arrow mark for center of mirror points to height scale (units in
mm)
|
1 690 386 085 2018-08-21
6. Rotate vertical release to the left.
!
Measurements at a distance greater than 500 mm:
carabiner must be attached.
!
Measurements at a distance less than 500 mm:
1. Hold the mirror frame securely with one hand.
2. Lower the mirror and base slide gauge to a height of
approx. 600 mm.
1
Abb. 13: Securing cable attached
1 Securing cable with carabiner
2 Eyebolt
1. Place the vertical release in the Upwards position.
2. Detach securing cable with carabiner from eyebolt.
1
3. Place the vertical release in the Downwards positi-
on.
4. Lower the mirror and base slide gauge carefully to
the desired height.
5. Place the vertical release back in the Upwards posi-
tion again (rotate to the right) to hold in position
!
Two-hand operation: Use the handle to keep the mir-
ror unit from lowering too quickly before actuating
the release.
!
Risk of injury: Securing cable must be attached by
making measurements at a distance greater than
500 mm.
i
The height scale (units and millimeters) indicates
the height from the center of the mirror.
i
The required height position can be found in the
manufacturer's documentation.
!
The center of the mirror must point to the center
axis of the radar sensor.
Robert Bosch GmbH