Installation And Connection; Operating - Bartscher Vital-Washer Mode D'emploi


Do not lay the cable over carpets or heat insulations. Do not cover the cable.
Keep away the cable from operating range and do not dunk it into water.

Do not tip over the device.
WARNING! Hazard via electrical current!
The device can cause injuries due to improper installation!
Before installation the local power grid specification should be compared with
that of the device (see type label).
Connect the device only in case of compliance! Take note of the security advice!

5.2 Installation and connection


Discard the complete packing material after unpacking the device.

Place the device on top of an even and safe surface which supports the weight
of the device and make sure it cannot tilt at any time.

The device should be put in the vicinity of water terminal.

Not at any time should you place the device on an inflammable surface (such
as: table cloth, carpet, etc.).

You must not position the device near open fireplaces, electric ovens/arc
furnaces, furnaces/electric heaters or other heat sources.

Position the device in a way so that the plug is easily accessible.

5.3 Operating

Preparation

Connect the pipe supplying water to the device and then connect it carefully to a
tap. Water pressure should amount to approx. 3-8 bars.

Connect the outflow pipe to the device and put it in a sink so that water flows
after the washing process.
CAUTION!
The device should be connected only to a drinkable water terminal!
- 26 -