Troubleshooting - Bartscher Vital-Washer Mode D'emploi

7. Troubleshooting

In the case of a failure, take out the plug before you check the possibilities given below.
They are not always failures therefore it is necessary to make sure about this before
taking the device for repair. If there is a failure, take the device immediately to the
service and do not attempt to repair it yourself.
Failure
Lack or only a slight
flow of water
Lack or a slow outflow
of water
No
washing
The device
does not
work
No
rotation
Leaking tap
Cause

The tap is turned off
or there is no proper
inflow of water.

Blocked inflow

Too little water
pressure

The outflow pipe is
damaged
 The outflow pipe is
blocked.

Turned off

The plug is not
connected to the
socket

The level of water is
not low enough
 The plug is not
connected to the
socket correctly

Wrongly closed lid

The inflow pipe is not
connected to the tap
strongly enough or it
is connected the
wrong way round.
Solution

Turn off the tap, open once
and close the lid

Clean the inflow, open
once and then close the lid

Open and close the lid
once
 Put the pipe horizontally
and close the lid

Clean the outflow pipe,
open once and close the
lid

Turn on the device

Put the plug correctly

Increase the level of water

Put the plug correctly

Open and close the lid
once.
 Tighten up the screw well
- 31 -