Lamello Cantex Ergo Mode D'emploi page 7

Technical data
Cantex Ergo/Plano 45 S2 (120 V / 230 V)
Power
Speed
Cutting width
Weight of machine Plano
Weight of machine Cantex 4.3 kg
The Lamello Plano 45 and Lamello Cantex milling machines are suitable for flush-milling of projecting wooden com-
ponents, such as rosin gall patches, patching bars and knot repairs in the surface. With its enlarged baseplate, the
Cantex model can also be used for flush-milling of stripped edges. The plastic rule screwed to the baseplate can be
removed to mill edge strips projecting all round.
Basic equipment:
- Milling machine
- Toolset
- Wooden case
- Instructions for use
General
The height of the cutter head can be adjusted in steps of 0.035 mm (= 1 division). The milling machine is set as stan-
dard to "0", i.e. the cutter is flush with the supporting surface of the machine. The machine can be set down without
the cutter contacting the surface thanks to the supporting foot at the rear end of the baseplate (when the machine is
not used or if the cutter continues to run for a few seconds after switching off).
A) Directions for use
1. Set cutting depth with adjusting wheel: 1 division = 0.035 mm
The wheel should be turned in the plus zone to the right to cut more or
turned in the minus zone to the left to cut less
2. Switch on machine
3. Guide machine with both hands over the projecting piece of wood. Correct cutting depth if necessary and repeat
procedure until the required result is obtained.
4. Switch off machine
5. Put machine down so that the supporting foot prevents contact between cutter and surface
6. Withdraw power plug after finishing work
B) Changing the reversible tips
Use only perfectly sharpened and undamaged reversible tips!
Use only original Lamello reversible tips part no. 131822!
Wait for the cutter to stop before setting the tool down. An exposed cutter may engage the surface leading to possible
loss of control and serious injury.
1. Withdraw power plug
2. Release the 4 Torx screws with the screwdriver supplied Torx TX20
3. Lift motor unit from cutter case
4. Release screws of reversible tips with the screwdriver supplied Torx TX15
5. Turn or exchange reversible tips and re-tighten screws. Only original Lamello reversible tips part no. 131822
(45 x 12 x 1.5 mm) must be used. Ensure that all reversible tips lie evenly on the cutter head
6. Position motor unit in cutter case
7. Re-tighten the 4 Torx screws firmly
8. Check whether the cutter setting corresponds with the scale. Re-adjust scale if necessary with the screwdriver
supplied Torx TX10.
Cleaning
Blow out machine frequently
Repairs
Repairs to the the Lamello Plano 45 and Lamello Cantex milling machines may only be performed by the manuf-
acturer.
Carbon brushes
The motor is fitted with self-disconnecting carbon brushes. The motor stops when these have worn out . Only original
carbon brushes must be used as replacement (Lamello part no. 316006). Always change carbon brushes in pairs!
1'000 W
8'500 rpm
45 mm
4.1 kg
Special accessories (against surcharge)
Dust extraction comprising:
- Suction hose internal dia. 30 mm, per metre
- Tapered connecting piece 30 mm
- Reduction piece 54 mm
English
Part no.
331520
331803
331805