Lamello Cantex Ergo Mode D'emploi page 6

English
Safety instructions and liability
Warning - To reduce the risk of injury, user must read and understand instructional manual.
Please also read the enclosed general safety instructions carefully before putting your grooving machine into ser-
vice.
- When the grooving machine is not in use, before all servicing work, before changing the cutter, etc.: unplug the
cable!
- Ensure that the machine is switched off before inserting the plug in the socket.
- Check plug and cable for damage before inserting. If damage is found, replacement must be made immediately by
a technician.
- Make sure before starting the grooving machine that the rated voltage on the name-plate corresponds with the mains
voltage. The machine is only suitable for AC power supplies.
- The grooving machine is double-insulated and (conforming to CEE and VDE regulations) has a two-conductor cable
without ground conductor. The machine can be connected without risk to an ungrounded socket.
- Do not drill the motor case (e.g. to attach labels) since this damages the double insulation. Use only adhesive labels
for labelling.
- Clamp work tightly if possible and guide machine with both hands.
- Use clamps or another practicel way to secure and support the workpiece to a stable platform. Holding the work by
hand or against your body leaves it unstable and may lead to loss of control.
- Use only perfectly sharpened reversible tips, since otherwise increased cutting forces may shift the work away.
- Wait for the cutter to stop before setting the tool down. An exposed cutter may engage the surface leading to possible
loss of control and serious injury.
- Do not stop the cutter after switching off.
- The machine should only be used for the applications described in these operating instructions.
- Do not expose to rain or use in damp locations.
Manufacturer and retailer disclaim all product liability if the grooving machine is modified in any way from its original
state or condition as delivered, or if the grooving machine is used in a manner inconsistent with operating and safety
instructions.
CE Declaration of normity
We declare under our sole responsibility that this product is in conformity with the following standards or normative
documents:
EN 50144, EN 55014, EN 55014-1/A1, EN 55014-2, EN 61000-3-2, EN 61000-3-3 in accordance with the regulations
of directives 73/23/EEC, 89/392/EEC, 89/336/EEC.
Sound emission and vibration acceleration
Typically A-weighted noise levels of the tool are:
Sound pressure level = 92 dB (A)
Sound power level = 105 dB (A)
Wear ear protection!
Typically the hand-arm vibration is below 2.5 m/s
Lamello AG
CH-4416 Bubendorf
Guarantee
The guarantee is for a period of 12 months from the date of delivery, during which time all faults due to bad workmanship
or defects in materials will be rectified free of charge. Damage due to the application of excessive force, incorrect use
or normal wear and tear is not covered by the guarantee.
.
2
Karl Steiner
10.02.2000