Publicité
Les langues disponibles
Les langues disponibles
Custom oD 108 - t
U s e r m a n u a l
Installation
Loosen the two knobs. Remove the bracket from speaker (pic.A). Run the appropriate gauge wire
from your amplifier (pic. B). Mount the C-bracket to the wall surface by running screws through
the holes located in the bracket (pic.C).
Install the speaker into the C-bracket. Turn the bracket knobs into the cabinet. Point the speaker
toward the listening area (pic.D). You must respect the connector polarity of both loudspeakers
and amplifier. The positive terminal "+" must be connected to the corresponding amplifier terminal
and the negative terminal "-" to the negative terminal.
Running-in period
The drivers used in this speaker loudspeaker are complex mechanical devices and require a run-in
period before they deliver their best performance. They must get adapted to the temperature and
humidity conditions of their environment. This breaking-in period depends on the encountered
conditions and can last several weeks. In order to shorten this period, we advise you to let
your loudspeakers operate for about twenty hours at medium level, playing standard musical
programmes, but with a large amount of bass. Once the components of the loudspeakers are
completely stabilized, it is possible to enjoy the real performance of your loudspeakers.
Warning!
Long sun and/or bad weather exposure can damage your loudspeakers.
We recommend that you place your OD 108-T loudspeakers under a penthouse in summer and
to remove them in winter.
Cable gauge to use according to power and distance in 100V mode.
Power (Watts)
Length (meter)
50
0,75 mm
100
0,75 mm
200
0,75 mm
400
0,75 mm
600
1,5 mm
60
120
0,75 mm
0,75 mm
0,75 mm
1,5 mm
1,5 mm
200
300
0,75 mm
0,75 mm
0,75 mm
0,75 mm
1,5 mm
1,5 mm
2 mm
4 mm
4 mm
6 mm
400
500
0,75 mm
0,75 mm
1,5 mm
1,5 mm
2 mm
2,5 mm
4 mm
2
Publicité
