Installation And Commissioning Instruction; Power Supply Connection - Eneo IPB-62M2712M5A Guide D'installation Rapide

[ TIP ] Adjustment of viewing angle with 3-Axis bracket.
• Unlock the Lock/Unlock screw on the camera bracket using the driver.
• Adjust the camera's viewing angle then lock the Lock/Unlock screw and fix the
sub-lock screw on the other side of bracket.
(1) Lock/Unlock Screw
(2) Sub-Lock Screw

Installation and commissioning Instruction

• Make sure the power is removed before the installation.
• After all connections are finished properly, follow the order for applying power.
a) Plug the network cable into RJ-45 Ethernet Port. If PoE is the unique power,
there will be no need to connect Power terminal.
b) When DC12V Local power is necessary, connect the low voltage (DC12V) first,
then plug the DC adapter to DC outlets to avoid an improper reset from power jitter and
a damage from the surge voltage when no load.
When PoE and Local DC power are connected at the same time, Local pow-
er has priority.

Power Supply Connection

Camera can work with either 12VDC or PoE(IEEE Std. 802.3af ). Primary and secondary
grounds are completely isolated to avoid the possible ground loop problems.
Tilt
Inclination
EN
Pan
9