Installation And Commissioning Instructions - Eneo IED-62F0036M0A Mode D'emploi

Installation and commissioning Instructions

properly, follow the order for applying power.
1. Plug the network cable into RJ-45 Ethernet Port. If PoE is the unique power, there
will be no need to connect Power jack.
2.
then plug the DC adapter to DC outlets to avoid an improper reset from power
jitter and a damage from the surge voltage when no load.
i When PoE and Local DC power are connected at the same time, local power has pri-
ority. Camera can work with either DC12V or PoE(IEEE Std. 802.3af ). Primary and second-
ary grounds are completely isolated to avoid the possible ground loop problems.
EN
9