Install Batteries In Wireless Devices; Link All Devices To Wireless Network - Honeywell Home RedLINK TrueZONE HZ322 Guide D'installation

Install batteries in wireless devices

1
When system wiring is complete and TrueZONE panel is configured for RF,
install batteries in all devices. Make sure batteries are inserted properly (see
illustrations below).
Thermostat
Remote control (optional)
MCR32939

Link all devices to wireless network

2
Press
connect
Flashing status light times out after 15
minutes of inactivity. Press
necessary.
M28472
Install 2 fresh AA
batteries
Install 3 fresh AA
batteries
MCR33901
again if
connect
Français : voir la page 17 • Español: vea la página 32
M28473
Outdoor air sensor (optional)
Make sure the Connected light on the
wireless adapter is flashing green.
If the light stops flashing before you have
linked all devices, press
If light does not flash, another EIM/wireless
adapter may be in wireless setup mode. Exit
wireless setup at the other EIM/wireless adapter.
3
Programmable models only
Install quick reference card
Install 2 fresh AA
lithium batteries
M28444
again.
connect
Continued on next page >>
69-2090EFS—09
M28474