Honeywell Home RedLINK TrueZONE HZ322 Guide D'installation page 5

Link remote control to wireless network (optional)
WIRELESS SETUP
Press to link another
zone panel
YES
CONNECT MORE?
Link outdoor sensor to wireless network (optional)
Press and release
CONNECT
MCR32942
Press to save
and exit
NO
MCR33902
Français : voir la page 17 • Español: vea la página 32
1 Make sure the Connected light on the
wireless adapter is flashing.
2 Press
connect
be a short delay as the remote seeks a
signal from the wireless network.
3 When the screen displays "Connected,"
press .
done
4 Press
at the next screen to save and
no
exit. (Or press
to link another zone panel.)
If E1 appears, see error codes on page 12.
The linking procedure may time out if there is
no keypress within 30 minutes. To begin again,
press and hold the blank space (or arrow if pres-
ent) in the lower right corner of the screen until
the display changes (about 3 seconds)
1 Make sure the Connected light on the
wireless adapter is flashing.
2 Press the
connect
the sensor.
3 Check thermostat to verify that the out-
door sensor is working. After about 15
seconds, the thermostat should display
outdoor temperature and humidity.
(If you are installing more than one zone
panel, repeat steps 1-3 for each.)
5
at the remote. There will
and repeat steps 1-4
yes
button on the back of
69-2090EFS—09