Publicité
Les langues disponibles
Les langues disponibles
USE OF THE PROFESSIONAL
IRON (OPTIONAL)
Steam may cause serious injury if in
contact with body parts. Always allow the
steamer to cool down before handling.
To reduce the risk of personal injury
unplug the power cord from the electrical
outlet and let the appliance and the
accessories
before handling
Vaporetto can be quickly transformed into a
highly effective ironing system to make
ironing quick and easy. Simply connect the
product to the iron accessory for Vaporetto.
• Fill the boiler tank of the steam generator with
water as described in the user's manual for the
generator.
1d. Connect the connector assembly at the end
of the iron hose (4) to the generator as
shown in point 2a of the section "Instructions
for Use".
Check the manufacturer's label on the garment,
and interpret the symbol on the label as follows:
Steam ironing allowed
For dry ironing, set the temperature regula-
tion dial (Q2) on •••
Steam ironing allowed
For dry ironing, set the temperature regu-
lation dial (Q2) on ••
Check the fabric's resistance to steam iro-
ning or dry iron with the temperature regu-
lation dial (Q2) set on •
- do not iron
- steam ironing or treatment not allowed
STEAM IRONING
2d. For STEAM ironing, turn the dial (Q2) and
set the iron temperature to its maximum
travel on the "COTTON-LINEN" steam
position.
3d. Wait for a few minutes until the "Iron heating"
indicator light (Q5) goes out, to show that
the soleplate of the iron has reached the
required temperature.
VAPORETTO ECO CARE
cool
down
completely
4d. Press the steam request button (Q1) to
enable the steam to come out. The steam
flow will stop when the button is released.
After each filling, when you first start to use
the iron, a few drops of water mixed with the
steam may be emitted (due to imperfect heat
stabilization). It is therefore advisable to
direct the first jet of steam onto a rag.
5d. The iron can also be used in a vertical
position e.g. for removing creases from
curtain, clothing etc.
6d. To obtain a continuous jet of steam move the
sliding button (Q4). The steam will continue
to come out even when the steam request
button (Q1) is released. To stop the steam
flow move the sliding button backwards
(Q4).
When using the iron accessory, it is
recommended that the steam flow of your ap-
pliance be adjusted to a medium level, or make
a few tests to find the most suitable emission for
the fabric that you intend to iron.
DRY IRONING
7d. If you need to DRY iron (ONLY) (NOT steam
ironing), press the accessory on/off switch
(C) and adjust the temperature of the iron by
turning dial (Q2) to the temperature required
for the fabric (as shown on the dial).
request button (Q1), as hot water could come
out of the iron onto your garment and board.
• Do not leave the iron unattended whilst
connected to the electrical outlet.
• Iron only on heat resistant surfaces and on
surfaces that allow the steam to escape e.g.
MESH ironing boards.
•
the ironing board, the steam can cause burns.
11
when dry ironing, be careful
not to press the steam
if you iron sitting down, do
not place your legs under
Publicité
