Jenn-Air Bella Web Guide D'utilisation Et D'entretien page 30

Pull-Out Platter
To remove and replace Pull-Out Platter:
NOTE: Refrigerator doors will need to be removed to remove
platter pocket. See the "Remove and Replace Refrigerator Doors"
section for more information.
1. Pull the pull-out platter to the fully open position or when
it stops.
2. Locate the pull-out platter retention clips on both sides.
These are in the side under the pull-out platter.
3. Push the clip up from the bottom with your finger.
4. After both clips have been disengaged, carefully remove
the pull-out platter toward the front of the refrigerator.
Humidiseal™ Crisper Drawers
To remove and replace the drawers:
1. Grasp the handle at the bottom of the drawer and slide the
drawer straight out to the stop. Lift the drawer off the bottom
guide.
2. Replace the drawer by placing it on the bottom drawer guide
and pushing it past the drawer stop into position.
To remove the crispers cover:
1. Remove the pull-out platter first.
2. Holding the glass insert firmly with one hand, press up in
center of glass insert until it rises above the plastic frame.
Gently slide the glass insert forward to remove.
30
To replace crisper(s) cover:
1. Remove the crisper pan, pull-out platter, and crisper glass
before removing the crisper.
2. Fit back of cover frame into supports on side walls of the
refrigerator and lower the front of the cover frame into place.
3. Slide rear of glass insert into cover frame and lower front into
place.
Refrigerator Door Bins
The bins on your refrigerator door are adjustable to meet your
individual storage needs. The gallon-sized bins make it easy to
customize door storage to hold gallon containers.
Door Bin Divider (on some models)
This divider fits in the door bin to divide the bin and elevate
smaller items at the back of the bin.
Herb Tender™ Container
A container to store herbs and the water to keep them fresh
is located within the herb bin. For your convenience, you can
reposition the Herb Tender™ container anywhere in the bin.