Jenn-Air Bella Web Guide D'utilisation Et D'entretien page 19

1. Push the water filter door to open, located at the bottom left
of refrigerator compartment.
2. Twist the water filter and turn 90° counterclockwise to unlock.
3. Pull the filter out of the housing.
4. Remove the water filter cap from the water filter being
replaced.
5. Install the water filter cap onto the new filter. Be sure to align
the arrows so the groves in filter align with ribs in filter cap.
6. Insert the filter into the housing.
7. Twist the water filter and turn 90° clockwise until it locks into
place and the arrows are aligned.
8. Push the water filter door closed.
The Water Filter Status Lights
The Water Filter status lights will help you know when to change
your water filter. The app will also send notifications to your
mobile device and tell you the status of the Jenn-Air app for
the filter life.
ORDER FILTER (yellow) - It is almost time to change the
■
water filter. "Order Filter" display is ON all of the time but
OFF in Showroom mode and Sabbath mode.
REPLACE FILTER (red) - Replace the water filter. While you
■
are dispensing water, "Replace Filter" will blink 7 times and
an alert tone will sound 3 times.
NOTE: "REPLACE FILTER" will remain illuminated if the filter
is not reset on the user interface (UI).
RESET FILTER - Touch MAX COOL and MAX ICE for
■
3 seconds to reset water filter. The display will do a
3-second countdown, then flash the icon and play a tone.
19